3 Point Retractable Seat Belt OE Seatbelt Buckle for Convertibles or Hardtops

Sewn, Assembled, Safety Tested and Approved, Packaged in the USA and Federal Safety (FMVSS) #302 & #209 Rated!
3 Point Retractable Seatbelt • Remanufactured OE Metal Buckle • For Convertibles, Hardtop Muscle Cars or Trucks Aftermarket universal fit replacement truck or car safety harness. Vintage Remanufactured OE brushed metal buckle all other components new. Buy this OE metal buckle safety seatbelt.

Both lap and shoulder 3 point seat belt.

FMVSS #209 and #302 Federally Safety Certified.

Safety tested and approved, assembled, sewn, packaged in the USA.

Choice of: 20 inch Bench Seat Floppy End20 inch Bench Seat Floppy End,   11" or 8" Rigid Sleeve End for Normal to High or Low Bucket Seats.

For vehicles where the Shoulder Anchor Point is below the bottom of the side window. Click HereFor convertible or hardtop cars where shoulder sash anchor point is just below bottom of side window level.

Price includes 1 seat belt for 1 seat / person.

Works for both passenger side or driver side, front and most back seat applications.

Webbing (belt) extends up to 120" out of retractor box. "Hey Wesco, how do I figure out what seat belt length will work?" No Problem, here ya go! See Our Seat Belt Install Measuring Instructions

Retracts neatly out of the way when you unbuckle.

Equipped with ELR Retractor What's That? for minimum restriction while driving AND Maximum Safety

Installation Instructions

For front seat installations with a high middle console (17" or more when measured from floor to top of console), one 6 inch extension bracket # 6-AB is needed for each seatbelt installed (front seat). Click Here6 inch extension bracket needed for center consoles that are higher than 17 inches. to see how it attaches to the seatbelt end.
Compare our detailed installation diagrams and instructions to your vehicle to make sure that this seat belt is compatible with your car. Some modification to your auto might be necessary. The retractor box is H: 4" x W: 4" x D: 3" and you want to make sure that you have sufficient space at the installation point area near or on the floor of your car to accommodate the retractor. Note: To install a 3 point seat belt, your auto must have a manufacturer's shoulder bolt attachment point or you must create one (retrofit one). How do I create one? Click Here to See!
Optional hardware kitOptional Hardware Kit Includes All that is Shown. includes HW#12 Bolt Kit Mounting Hardware, plus 1 Angle Bracket, 1 Shoulder Bolt & 1 Mounting Plate. Or see our Seat Belt Hardware Page.
What the Heck is a Hardtop? Click Here
What is a convertible? Click Here
Note: These seatbelts do NOT have electrical wiring, so they cannot be electrically wired to alarms or airbags.